• From the OVA Mobile Suit Gundam Wing: Endless Waltz comes the newest Perfect Grade kit: the Wing Zero Custom!
  
• With a wingspan of over 27 inches and a height of 11 inches, this kit’s impressive silhouette eclipses many other Suits both in height and width! 
  
• Die-cast joint parts give the Suit a sturdy construction and low center of gravity and enable the builder to tighten them easily if needed.
  
• Rear center wings can be expanded with a spring mechanism for cleaning, and the large side wing’s feathers extend to give an impressive wingspan.
  
• Shoulder-mounted Vulcan Cannon hatches can be opened, and the cockpit hatch slides forward to open and reveal pilot Heero Yuy
  
• Center chest and “eye” cameras light up using included LEDs (batteries required)
  
• Rifle accurately moulded, fingers individually jointed and camera eyes moulded in transparent colored elements. 
  
• 
  
• Accessories: Accessories: Twin Buster Rifle, Beam Saber x2
  

• It is the brand new frame compatible for the non-transforming 4 out of the 5 Gundams 
  
• Derived from Wing Gundam Zero (Wing Gundam, Gundam Deathscythe, Gundam Heavyarms, Gundam Sandlock, & Shenron Gundam). 
  
• The snap mechanism of the wrist has been employed, to increase the poseability with weapons in hand, the forward and backwards movement range has been obtained. 
  
• Buster Shield: The beam effect part can be attached for the Claw Expanded mode. - Beam Scythe: The beam parts has been made with clear material, and can be detached. and equipped to the backpack. 
  
• Katoki Hajime has designed the markings. 
  
• Accessories: Beam Scythe, Buster Shield, Beam Parts for the Buster Shield Weight: 543g
  

• The stylish form rebuilt by Katoki had been reproduced. 
  
• Equipped with the wing area adjustment gimmick, with wide posing range. 
  
• Able to transform into the Bird mode. With the wings at center, the front/back balance had been pursued for a greater flight mode. 
  
• The action gimmick for the weapons has been reproduced too. The barrel can be taken down, and the saber will pop out. 
  
• Equipped with a locking mechanism during transformation. The rifle can be locked to increase stability. By cranking the side armor, the base of the arm shaft is locked, also locking the mobility of the waist during MS mode. This stabilizes the Bird mode. 
• - Leg transformation mechanism equipped. Linked with the knee joint, the ankle will move to it's storage position. (The ankle will be stored in the shin, reducing the total length) 
• - The cockpit has been reproduced, with the figurine included. The figurine of Heero has been reproduced at 1/100 scale with immense detail. The cockpit hatch can be liberated to open, to reveal Heero in his shirt. - Weapon/Accessories: Shield, Beam Saber, Buster Rifle, Heero Figurine Weight :591g
  

BB-203 Wing Zero Gundam Custom Simple instruction included in a box. Weight: 500g Rare BB Gundam, hurry grab it while stock limited

• Following EW ver. Death Scythe rated No.01 for item of most interest at the Tokyo Hobby Show MG booth, the Death Scythe Hell takes off! 
  
• Uses the XXX-G Frame developed during the animation!
  
• Marking work is designed by Hajime Katoki.
  
• Increased freedom of movement when set on Action Base, by the placement of joint at the wing connection part.
  
• New gimmick and mechanism equipped to the Active Cloak. By pulling from the base part of the wing, the internal machinery will appear. 
  
• Able to reproduce the flapping from the animation naturally. 
  
• The closed state of the Active Cloak can also be reproduced with a natural form. 
  
• Accessories: Beam Scissors, Active Cloak Technology & Combat Characteristics The Gundam Deathscythe was the "masterpiece" of Professor G. 
  

• Best weapon can reproduce the cross-Sand Rock Crusher! - Combine the two bright show heat can also be a single weapon. Tell a cross-section shows Heat Crusher is left open to work. - Included beam machine gun! 
  
• Movable beam machine gun in stock and grip, can be transformed into storage forms.
  
• Accessories: shield, Huixiang x 2 Heat a large beam machine gun 
  

• The first 5 [G] Hebiamuzu appearance! 
  
• Flexible movement on it's posture, with BIG ARM weapon - Accessories: Shield, beam gatling, army k-nife, concealed arms (saber charged)
  

• From "New Mobile Report Gundam W Endless Waltz The Glory of Losers", Wing Gundam Proto Zero appears as MG. 
• The parts are completely newly molded and functions for the full transformation are accommodated. The movable frames made of new materials are paintable. 
• Full transformation of MS -  ?? Neo-Bird can be re-created with various gimmicks such as the 180 degrees rotation of its head part and the lower body part. 
• The conspicuous wings have various gimmicks such as the deployment function. The side armor fins on its waist are movable. 
• The hatches of the machine cannons on its shoulders are openable. The quadruple barreled Vulcan is precisely re-created. 
• The shoulder armor is dual structure and openable. The storage gimmicks for the beam saber on its shoulder and Verniers inside of the shoulder armor are precisely re-created. 
• The overwhelming "Twin Buster Rifle" can be separated into the right and left. 
• The original marking produced by Hajime Katoki is included. 
• A display stand is included. The special joints for the kit make it possible to display it in MS mode and Neo-Bird mode in midair. 
• Runner x18, Foil sticker x1, Dry decal x1, Tetron sticker x1, Instruction manual x1

[174] Wing Gundam Zero (HGAC)

• "Wing Gundam Zero EW" as Real Grade featuring detail is reproduced through the utilization of actual techniques, an investigation of the settings, and a new interpretation of the properties of the machine. 
  
• The structure of the main wing is based on material technologies used in real aircraft. 
  
• Considering the heat-resistance and machine protection during atmosphere entry, the armored structure for the interior of the wings is designed using a pinnate mold. 
  
• The main wing section utilizes cutting-edge aircraft and combat aircraft technology and is designed to have a movable structure. Closely resembling a bird's wings, each section of the curved "flexible wings" is capable of moving in 3-dimensions. 
  
• The "Zero Frame", which can move by itself, is designed through consideration of the internal structure of the latest autonomous robots. 
  
• The utilization of new Advanced MS Joints permits human-like movements. 
  
• The Twin Buster Rifle Combination Mechanism can be reproduced. 
  
• Runner x9, Realistic decal x1, Instruction manual x1 
  

- Accessories: Dover gun, shield, beam saber dolls Standing × 2,1 / 100 ZX Doll 1/100 ZX pilot, fist (left and right), palm (left and right), hand grip for arms (left and right) 

• An accurate, realistic take on a classic Mobile Suit, Mobile Suit Gundam Wing: Endless Waltz's angelic Wing Gundam Zero fills the next slot in the prestigious Real Grade line! 
• With an incredible amount of unique detail drawn from much-researched realistic technology, this Real Grade model is the closest to the real thing so far. 
• Derived from modern aircraft designs, the Wing Zero's armor and wing surface feature advanced panelling. Internal wing details take into consideration the necessary components for defense and atmosphere re-entry heat, and are recreated in the Wing Zero's signature feather-like armor structure. 
• Based on cutting edge thrust control technology, this three-dimensional model's wings feature an aerodynamic sweeping design. Taking into account the thrust needed to propel a massive Suit like this in atmo, the massive wingspan is closer to the curved, bladelike wings of a bird than any other in the Wing Gundam line. 
• Utilizing an all-new Advanced MS Joint, this Suit features maneuverability approaching human levels. The internal structure of this self-contained mobile weapon is built with the correct proportions for the more compact Mobile Suits of the After Colony era for integration with all five Operation Meteor Gundam Suits. 

SD Ex-Standard Gundam Deathscythe Hell Ew

The highly anticipated Tall geese EW now joined the RG kit series ! Unique to the RG line, the Tall geese EW utilizes several gimmicks to emulate the heavy armor and thrusting power of the mobile suit as seen in the anime. 

Starting of 2019 and  BANDAI TAMASHII NATIONS has announced  in Hong Kong releasing GUNDAM UNIVERSE which are 6" articulated figures.

DABAN 6620 MG 1/100 Tallgeese Gundam

[Set Contents]:

[Includes]:

* Beam Glaive
* Shenlong Shield
* Interchangeable hands (left and right, x3 each)
* Dragon Hang expansion and contraction joint (x2)
* Stickers